AN-28 beta-2 for X-Plane 9.6
| Rating: 5!
+1
5
a lot of work, but much effort. will be a time - potestiruyu more deeply and accomplish your goal in the corresponding branch
− Felis,
15 years ago,
#
Thanks, Guru opinion will be very helpful!
− DPL,
15 years ago,
#
5
Fantastic job DPL! I sent you an e-mail. But to be sure I will also ask here... Could you be so kind and give me rights to make FSX version of your plane, using your mesh and textures? All your rights will be reserved. The plane will be freeware. All details were included in PM sent to your account here. Cheers!
− IntruderPL,
14 years ago,
#
5
Thank you!
− Poltynnyk,
15 years ago,
#
5
waited. Now let's try:)
− inv,
15 years ago,
#
5
.
− Jenya77,
15 years ago,
#
5
I'll be learning.
− koguch,
15 years ago,
#
5
For the effort, only control some coarse.
− Leonidos,
15 years ago,
#
It is small, light weight (6 tons) and nimble! A square control surfaces, relatively, very large. Just carefully!
− DPL,
15 years ago,
#
I have it for some reason all the time right away (
− Leonidos,
15 years ago,
#
So it should be, because the screws rotate in one direction! Use your trimmer aileron. If not possible, then put pleynmeykere rotation propellers in opposite directions.
− DPL,
15 years ago,
#
5
Even better was, surprisingly you can, but finding fault in the same without an autopilot does not make a great flight, especially since it tends a little to the right and need trimmirovat ailerons, although goes smoothly, steadily. Autopilot would voice meters before landing in Russian))
− Wlad90,
15 years ago,
#
Well, the screws in one side of the spinning, that's getting at .... About the voice acting, so I did not even make it: (First Now for restrictions with respect to systems failures, there is still work to do.
− DPL,
15 years ago,
#